​(907) 342-2141

(855) 915-2628

Made in USA

Tacoma, WA

Home is the toughest waters on Earth. 

Example Vessel Specifications and Equipment List

This below list of vessel specifications is an example of a 'typical' build. 

We can make changes.  Choose your engines, electronics, seating configuration, head configuration. 

XTAERO XT24DV Long Cabin

  • Length Overall 27' / Beam 8'6" / Draft 16"
  • Towing weight wet 7,500lbs (Includes Trailer)
  • Trailer weight 1,300lbs
  • 1/4" bottom alloy 5086H116
  • 3/16" sides alloy 5052H32
  • 3/8" center vertical keel stem to stern with breast hook construction
  • Deep vee bow design for extremely smooth ride
  • Dead rise 20 degrees at transom
  • Full Lifetime Hull Warranty
  • White/White exterior paint finish with TACO rub rail
  • Randolph non-skid and custom hull striping. Customer can choose a three color accent striping
  • Factory installed transom vessel name
  • Decks slope downward and back slightly for self bailing feature
  • Dry bilge design concept w/ threaded drain hole and dual bilge pumps for safety


  • Captains chair custom Bentley bolstering ballistic nylon w/ SeaSpension and articulating arm rests, moves fore/aft and swivels
  • Captains station allows for stand up or sit down driving. Cabin headroom 6'4" at stand-up helm, just under 7' in center cabin
  • 360 degree visibility from helm / cabin sliding door by DSG
  • Cockpit depth 32" enclosed gunwale w/ no step down into cabin
  • DINETTE with aft bench facing forward with table. Front facing custom suspension seat that swivels around to face the table.
  • Finished cabin interior with custom WOOD trim , custom Bentley's ballistic nylon fabric cushions on dinette.
  • Cuddy bed covered in marine vinyl Whisper Charcoal
  • Bed is 7' long sleeps two
  • Storage compartments large below deck in several locations
  • GALLEY cabinet starboard side of cabin with four cup holders, door with shelves
  • Isotherm fridge: Drawer 49 Stainless Steel Refrigerator / Freezer, AC/DC
  • HEATER / Furnace. Espar with custom aluminum external tank
  • Self bailing decks, welded and water diverted overboard, not into bilge
  • Below deck fish boxes with macerator pumps


  • Aft helm installed with steering, engine controls and shore power plug
  • LED Flood light in cockpit
  • HEAD: Cockpit stand-up head port side of cockpit, includes black water tank, Y valve
  • Gasoline 140 gallons between dual 3/16" thick aluminum tanks with dual selector valvles
  • Water Separator/Gas Filter one for each engine
  • RAW / SEA WATER thru hulls for Johnson wash down pump w/ thru hull ball valve
  • FRESH WATER 9 gallon tank with hose in cockpit includes second water pump
  • Bait station in transom drains directly overboard (this is large transom sink for cleaning hands/tools, etc.)
  • Generator locker in transom with closing lid
  • Hand rails all welded with doubler plates
  • Welded trim tab doubler plates
  • Lenco Trim Tabs with LED switch
  • Welded transducer bracket (external of transom so no thru bolts)
  • Welded zinc bracket (external of transom so no thru bolts)
  • Welded/threaded drain plug


  • Dual electric horns (SeaDog)
  • Dual multi-speed AFI wipers w/ independent switching
  • 900gph bilge pump
  • BlueSea electrical bus (+) and (-),
  • BlueSea battery switches
  • Individual battery health gauges
  • Battery Switch / Master battery switch at helm (BlueSea)
  • Additional house Master battery switch at main panel (BlueSea)
  • Dual USB Smart Phone Chargers / 12v Chargers (BlueSea)
  • Four Interstate G27 lead acid batteries. Two house batteries
  • LED Flood Light forward on radar pedestal
  • 12 welded rod holders cabin sides
  • Shore Power inlet on aft helm assembly
  • Galvanic Isolator
  • GFCI outlets in cabin for AC availability when on generator or shore power (think microwave or coffee maker)
  • Batteries hard wired to the battery charger
  • Battery charger hard wired to AC / shore power system for charging on either shore power or generator while underway
  • Generator Locker for a factory supplied Honda EU100 generator


  • Twin Suzuki DF200AP with Aft Steering Helm, stainless propellers


  • Garmin 7610xsv Smartchart with SideVü, ClearVü and Traditional CHIRP Sonar with Mapping capabilities (GT51M-TM)
  • Johnny Ray™ Pedestal for quick connect
  • Garmin 18xHD radar dome
  • Garmin GT51 (chirp style) DownVu™ transducer
  • SIMRAD RS35 VHF with AIS and DSC & 8' antenna


  • Anchor Winch: Lewmar 700 with local foot controls
  • Pot Puller Electra-Dyne ED7500-10 XXHD SS and custom davit
  • Dual Cannon 5ST Electric Downriggers
  • 32# Bruce Anchor w/ 600' 1/2" line and 25' Chain
  • Four fenders, four dock lines, four life jackets, USCG approved noise maker, boat hook, flares & fire extinguisher.


  • Heavy Duty Karavan aluminum I-beam w/dual axle electric over hydraulic brakes, LED lighting, bunk w/ plastic coverings.

MSRP Price $209,670

Note: We are seeking a demo boat in the Tacoma, WA area to be a 'Factory Demo Boat' We will assist in keeping the boat in the water at Point Defiance. Comes with significant factory incentives.

For more information contact builder

Travis Brandt  907.342.2141

or email akinfo@xtaeroboats.com

Xtaero Aluminum Boats typically builds to suit each customer.  The list below is an example of an XT24DV Long Cabin being constructed for a businessman near Stockton, CA.  In reality each buyer customizes their line item build menu and we build to suit.   The list of possible installed equipment is very long. 

Xtaero Aluminum Boats TWIN Outboard

As of 3-16-2018